413 Series Shocks 2000 & later Harley Davidson Softails

Follow instructions in an authorized shop manual or. take the motorcycle to a competent dealer. … a Harley Davidson pre-load adjustment wrench is neces- …

More PDF Content

413 Series Shocks 2000 & later Harley Davidson Softails
Page 1
Inst # 3098-102 8/01 11129 G Avenue Hesperia, CA 92345 www.progressivesuspension.com (760) 948-4012 Fax (760) 948-4307 Copyright © 2001 by Progressive Suspension, Inc. All Rights Reserved. Caution Please read the following instructions completely before starting installation! Follow instructions in an authorized shop manual or take the motorcycle to a competent dealer. The motorcycle must be securely blocked to prevent it from tipping over when the shocks are removed. Failure to do so can cause serious damage or injury. The use of lowering kits on Progressive Suspension shocks is not recommended. Use of a lowering kit may void the warranty or damage the shock/motorcycle. Progressive Suspension shocks are designed to work on the OEM (Original Equipment) frame and swingarm. Use of these shocks on a frame or swingarm other than OEM may produce an unsatisfactory ride and void the warranty. Transmission bolts must be installed in the OEM posi- tion to insure proper clearances for the shocks. Consult your factory shop manual for proper installation. Make sure that proper bushings/sleeves are installed in the shocks. Improper bushings/sleeves can cause unsat- isfactory and/or unsafe operation (see the instructions packaged with the mounting hardware). Progressive Suspension shocks for your 2000 & later Softail are designed as a direct bolt on replacement for your stock units. Although they are very similar in appearance, along with offer- ing adjustable ride height they also have improved damping and spring rates. Installation 1. Place motorcycle securely on stand or blocks so the rear wheel is slightly off the ground. 2. Per instructions in a authorized shop manual, remove your old shocks. Note location of the mounting hard- ware. 3. Before reinstalling a Progressive Suspension adjustable ride height shock, spin the non-flanged nut all the way onto the stud mount, followed by a bushing-cup, bushing, 413 Series Shocks For 2000 & later Harley Davidson Softails Installation Instructions Installation Instructions Installation Instructions Installation Instructions Installation Instructions and sleeve. Then install shocks as you would a stock unit, following an authorized shop manual. With the non- flanged nut spun all the way onto the stud, the stock ride height is achieved. Once you have installed the other bushing, bushing-cup, and flanged nut you can now in- stall the safety E-clip. This E-clip is snapped into the groove near the end of the stud mount where the threads stop. This is to serve as a reference point ONLY – when the flanged-nut reaches it you have lowered your ride height the maximum 2 inches. DO NOT torque the flange-nut against t

Download 413 Series Shocks 2000 & later Harley Davidson Softails pdf from www.progressivesuspension.com, 2 pages, 55.41KB.
Related Books

Leave a Reply