Free PDF eBook | FileMount.com

More PDF Content

Mazda Speed 3 TWM Performance Short Throw Shifter Installation Manual
Page 1
This install manual is available for download in color at: www.twmperformance.com Mazda Speed 3 TWM Performance Short Throw Shifter Installation Manual Please Note: It is preferable to park on a flat surface, as you will have to engage and disengage the hand brake and shift from gears to neutral. If you cannot do so and are obliged to install the short shifter on a slightly inclined surface, place wooden blocks in front or behind the wheels to prevent the car from moving while you are working. Estimated Installation Time: 60 Minutes Tools Required: -Philips head screw Driver -1 small and 1 large flat head screw driver -8mm and 10mm socket -Ratchet with extension -Needle nose pliers or needle nose Vice Grips -T-20 Torx screwdriver or bit -White lithium based grease is recommended -The help of an assistant is recommended 1. Unscrew the stock shift knob by rotating it counter clockwise.
Page 2
This install manual is available for download in color at: www.twmperformance.com 2. Open the storage compartment in the center console and remove the foam rubber mat in the bottom to access the 2 bolts. Use an 8mm socket and ratchet with an extension to remove the 2 bolts. 3. Lift up on the rear half of the console to begin removal. The rear portion can be removed from the car and put in a safe place. 4. Continue console removal by lifting the front of the console with the shift boot attached. The front portion of the console can now be removed and put in a safe place.
Page 3
This install manual is available for download in color at: www.twmperformance.com 5. Unscrew the two 8mm bolts at the front of the console with an 8mm socket and ratchet or a Philips head screwdriver. 6. Remove the ashtray if your car is equipped with one by pulling up and out. 7. Remove the lighter face plate by pulling up and out. Use both hands to remove the plate, one below the small door and one above. The cables connected to the back of the plate can be left connected, simply set the face plate aside on the driver’s side so it is out of the way of the center console.
Page 4
This install manual is available for download in color at: www.twmperformance.com 8. Use a ratchet and an 8 mm socket to remove the 2 bolts exposed by removing the lighter face plate. 9. The center console can now be backed up a few inches to access the white plastic connector which provides power to the rear compartment in the center console. Disconnect the white plastic connector to free the center console from the harness and enable it to be removed from the car. 10. Remove the entire center console from the car by lifting up and back.
Page 5
This install manual is available for do