2001 Buick Park Avenue Owner’s Manual

If an option of towing wiring added …… diagram. Key A.. Jack B.. Jack C. Container. D. Coverage spare. E. Chilton Repair and maintenance of ….

More PDF Content

2001 Buick Park Avenue Owner\’s Manual
You will hear positions have been entered into memory. To set the seat and mirror positions for a second driver, the MEMORY button (1 or 2) which corresponds to the DRIVER # identified by the second transmitter. To store the exit position for an easy exit, use the 1.First identify the DRIVER # by pressing the MEMORY button (1 or 2) or by pressing the button with the unlock symbol on the transmitter. 2.Adjust the driver\’s seat to the desired exit position. 3.Press and hold the EXIT button for longer than three seconds. You will hear two beeps confirming that the seat exit position has been entered into memory. To set the exit position for a second driver, follow the MEMORY button (1 or 2) which corresponds to the DRIVER # identified by the other transmitter. To recall your memory positions, your vehicle must be in PARK (P). Push and release the MEMORY button (1 or 2) corresponding to the desired driving position. The seat and mirrors will move to the position previously stored for the identified driver. You will hear one beep.
To stop recall movement of the seat at any time, press the driver\’s power seat control located on the outboard To recall the exit position, your vehicle must be in PARK (P). Push and release the EXIT button and the the current identified driver. You will hear one beep. identified driver, the seat will move all the way back. transmitter, see Personal Choice Features, Memory Heated Seats (Option) The heated seat controls are feature off. system is in use. When the ignition is turned off, the heating element is also turned off. Reclining Front Seatbacks The vertical control described previously in this section But don\’t have a seatback reclined if your vehicle is moving. Sitting in a reclined position when your vehicle is in motion can be dangerous.
Even if you buckle you\’re reclined like this. could go into it, receiving neck or other injuries. The lap belt can\’t do its job either. In a crash the forces would be there, not at your pelvic bones. For proper protection when the vehicle is in motion, have the seatback upright. Then sit well back in the seat and wear your safety belt properly. Head Restraints There are three different positions for the rear seat head Safety Belts: They\’re for Everyone properly. It also tells you some things you should not do Don\’t let anyone ride where he or she can\’t wear a safety belt properly. If you are in a crash and you\’re not wearing a safety belt, your injuries can be much worse. You can hit things inside the vehicle or be ejected from it.
Air bag inflation doesn\’t prevent the driver from seeing or being able to steer the vehicle, nor does it stop people from leaving the vehicle. When an air bag inflates, there is dust in the air. This dust could cause breathing problems for breathing trouble. To avoid this, everyone in the If you have breathing problems but can\’t get out fresh air by opening a window or a door. air bag system. If you don\’t get them, the air bag system won\’t be there to help protect you in another Your vehicle is equipped with a crash sensing and the system commands air bag inflation and driver\’s Let only qualified technicians work on your air bag systems. Improper service can mean that an air bag system won\’t work properly.
To make the belt shorter, pull its free end as shown until shoulder belt. If the belt isn\’t long enough, It\’s very important for rear seat passengers to buckle up! Rear passengers who aren\’t safety belted can be thrown Shoulder Belt belts. Here\’s how to wear one properly. 1.Pick up the latch plate and pull the belt across you. Don\’t let it get twisted. you very quickly. If this happens, let the belt go back more slowly. 2.Push the latch plate into the buckle until it clicks. If the belt stops before it reaches the buckle, tilt the latch plate and keep pulling until you can buckle it. Pull up on the latch plate to make sure it is secure.
When purchasing a child restraint, be sure it is designed to be used in a motor vehicle. If it is, the restraint will have a label saying that it meets federal motor vehicle safety standards. The restraint manufacturer\’s instructions that necessary because a newborn infant\’s neck is weak and its head weighs so much compared with the rest of its body. In a crash, an infant in a rear facing seat settles into the restraint, so the crash forces can be distributed across the strongest part of an infant\’s body, the back and shoulders.
All doors automatically lock when shifted out of PARK (P). All doors automatically unlock when shifted into PARK (P). Each remote keyless entry transmitter can be programmed to a different mode according to the user\’s preference. To change modes: 1.Close all the doors and turn the ignition on. Keep all 2.Press and hold LOCK on the power door lock switch on the driver\’s door through Step 4. 3.Press the button with the lock symbol on the remote 4.Press the button with the lock symbol on the driver\’s door would unlock.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference received, including interference that may cause undesired operation of the device. PASS When the PASS using the wrong key, it shuts down the vehicle\’s starter have a damaged transponder. Turn the ignition off and be undamaged, try another ignition key. At this time, not start with the other key, your vehicle needs service. If your vehicle does start, the first key may be faulty. See your dealer who can service the PASS It is possible for the PASS transponder value of a new or replacement key. Up to This procedure is for learning additional keys only. only a GM dealer can service PASS keys made.
Starter Switch Check When you are doing this check, the vehicle could move suddenly. If it does, you or others could be injured. Follow the steps below. 1.Before you start, be sure you have enough room 2.Firmly apply both the parking brake and the regular brake. See Parking Brake in the Index if necessary. ready to turn off the engine immediately if it starts. 3.Try to start the engine in each gear. The starter should work only in PARK (P) or NEUTRAL (N). Automatic Transaxle Shift Lock Control When you are doing this check, the vehicle could move suddenly. If it does, you or others could be injured. Follow the steps below. 1.Before you start, be sure you have enough room 2.Firmly apply the parking brake.

Download 2001 Buick Park Avenue Owner's Manual pdf from www.extendedgmwarranty.com, 392 pages, 2775.74KB.
Related Books

14 Responses to “2001 Buick Park Avenue Owner’s Manual”

  1. kitchen islandkitchen island cartkitchen island ideaskitchen island tablekitchen island designsportable kitchen islandkitchen island with seatingkitchen island lightingdiy kitchen islandisland kitchensmall kitchen islandrolling kitchen islandbutcher block on August 26th, 2014 at 10:21 pm

    –For slightly more stubborn stains, make a paste of baking soda and water, or talc with a diluted solution of bleach ammonia, or
    hydrogen peroxide. The house goes up on the market tomorrow and with this complete
    refacing of the kitchen, we expect to get very close to our listing price.
    There are discussion questions to use for assessment though.

Leave a Reply