Crusader Water Separating Fuel Filter Installation Instructions Kit RK080033

RK080033-IS. – RK080033 -. Fuel / water separator. Installation, operation, and spare parts. Started ….

More PDF Content

Crusader Water Separating Fuel Filter Installation Instructions Kit RK080033
Specifications
Fuel Ports (SAE J476): 3/8inch-18 NPTF
Maximum Flow Rate: 90 GPH / 340 LPH
Element Removal, Min. underneath clearance req’d: 1 in. / 25 mm
Clean Pressure Drop: 0.61 psi / 4.23 kPa
Height: 11 in. / 280 mm
Width: 4.2 in. / 106 mm
Depth: 4.5 in. / 114 mm
Weight, Dry: 3 lb / 1.4 kg
Temperature Rating: -40° / 255° F (-40° / 121° C
Clean any debris or dirt away from the Crusader head/filter joint prior to removal.

  1. Place a suitable container below the unit to collect the contaminants.
  2. Close the valve at the fuel tank (if applicable) and then remove the drain plug to empty the filter of fuel.
  3. Spin the Element and Bowl off together (use a strap wrench on the element), then remove the bowl from the element.
  4. Clean the bowl O-ring gland and the sealing surface of the mounting head free of dirt, debris or gums.
  5. Apply clean motor oil to the new seal and to the bowl O-ring supplied with the new element.
  6. Place the new seal onto the top of the new element and the O-ring into the bowl gland.
  7. Spin the bowl onto the element, and then the two onto the head. Tighten snugly by hand – do not use tools.
  8. Prime the fuel system following the manufacturer’s procedure (also refer to ‘Priming the Crusader Filter)’

 

Download Crusader Water Separating Fuel Filter Installation Instructions Kit RK080033 pdf from www.crusaderengines.com, 7 pages, 204.37KB.
Related Books

Leave a Reply